Quickboost 1/72 F-16A/C Ejection Seat


QB 72013




any appropriate 1/72 kit


Scott Van Aken

Most kit ejection seats are rather lacking in detail, mainly due to the inability of ejection molding machines to provide very fine details. While these seats are fine if one is using a pilot figure, most kits could benefit from a replacement. This particular one is for the F-16A/C. It can be used on any F-16 kit as long as it fits into the cockpit tub. I have built kits where aftermarket seats are too wide or too tall so you might have to do some adjusting. The seat has a separate ejection handle and the little 'wings' on the upper portion of the seat are also separate.

Purchased by me for your enlightenment.

October 2016

Copyright ModelingMadness.com. All rights reserved.

If you would like your product reviewed fairly and fairly quickly, please contact the editor or see other details in the Note toContributors.