Hasegawa 1/48 Spitfire Mk.IX 'Continental Spitfire'
KIT #: | 09473 |
PRICE: | 2400 yen when new |
DECALS: | Two options |
REVIEWER: | Scott Van Aken |
NOTES: | 2003 Limited Edition. |
HISTORY |
The Supermarine Spitfire was one of those few aircraft that were produced from the first day of WWII right until the end of hostilities. The other that comes to mind is the Bf-109. Both of these aircraft underwent huge transformations and in the end, there were few, if any, parts interchangeable from the first versions to the last.
Along the way, a number of 'stop-gap' versions were developed, some of which were produced in greater numbers than the originally designed variant. One of those was the Spitfire IX. While awaiting the definitive Mk VIII airframes to be ready, the more powerful Merlin 60 series engines were attached to MkV airframes (some of which had previously been Mk II or Mk I airframes), and the Spitfire IX was born.
The inclusion of the Merlin 60 engines gave the Spitfire what it had been seeking; parity and even superiority over the German's FW-190A series. Such was the success of the Mk .IX that it saw action right until the end of the war; this despite even more powerful versions being produced.
THE KIT |
This kit was initially produced in 2001 and raised a storm of controversy amongst the modeling community when it was discovered that the fuselage was some 4 or 8 scale inches short (depending on who was doing the measuring. This doesn't seem like much, but those in the know were incensed by the difference and much was the fussing and fuming. Apparently there were other differences as there are aftermarket bits to replace the prop and the cannon access covers among the usual plethora of 'post production' bits like wheels, elevators and so on.
Acknowledging all of this, what is the kit itself like? Well, if you have built a Hasegawa kit in the last five years, this one will fall right into the same mold, so to speak. It is superbly molded and provides inserts for a number of parts of the airframe. This is to accommodate the usual variants that are so required for today's mainstream kit makers. Inserts are provided for the cannon access covers (only the skinny ones are provided), wing tips ( full span or 'clipped'), and the lower cowling (a 'normal' carb intake is in the kit). The kit also provides the late elevators, but does offer both the rounded and peaked rudder. Both three and four spoked wheel inserts are included as well as either round or 'flared' exhaust. Two different tail wheels are provided as well as tail wheel doors, though these are not germane to the Mk IX. One thing to note is that this boxing only comes with the 'late' horizontal stabs, so you cannot build an early version if you want to use aftermarket decals.
There is a very complete cockpit with all sorts of bits for the sidewalls and accessory compartment. Wing racks are included as are a pair of bombs. The canopy is a separate section, though I'm not sure if it can properly be posed open as these bits tend to be a bit thick in Hasegawa kits.
Instructions are excellent and use the normal (for Hasegawa) Gunze paint references as well as generic terms. Markings are included for two aircraft. One is with the postwar Italian Air Force in unpainted metal with a black nose anti-glare panel. The other is a standard RAF camouflaged aircraft minus the yellow wing leading edge with the French during 1944. Decals are the old school type with off white whites. They are also a bit thick and I believe that care should be taken when using setting solutions. Best way to apply Hasegawa kit decals is with fairly hot water as that softens the decal for a good fit.
CONCLUSIONS |
If you aren't fussy about the slightly short fuselage, it builds into a very nice model as you can see below. They can also be found 'used' for reasonable prices. If you want all the bells and whistles then get the Eduard kit, but this one is still worth building if you have one.
June 2024
Copyright ModelingMadness.com. All rights reserved. No reproduction in part or whole without express permission from the editor.
If you would like your product reviewed fairly and fairly quickly, please contact the editor or see other details in the Note to Contributors.