Ultracast 48211: F4F Wildcat seat without harness


Any 1/48 Wildcat


$9.95 CDN


Scott Van Aken


resin. S&h is $7.50 CDN 

This time, Ultracast provides a pair of seats that should fit any 1/48 F4F Wildcat. The difference from the others they offer is that these do not have the harness. This works quite well if you are planning to install a pilot figure or wish to use aftermarket harness sets. As you can see, the harness attachment points on the side are molded in place.

As with all Ultracast products, they are engineered to be very easy to remove from the pour stubs. Often nothing more involved than a sharp hobby knife is needed.

August 2009

Review copy courtesy of the fine folks at Ultracast. Visit them at their website.

If you would like your product reviewed fairly and fairly quickly, please contact the editor or see other details in the Note to Contributors.