Well, the
1/32 crowd got unslotted, unreinforced stabs and now the 1/48 group can have
them too. These are for those early Phantoms or perhaps an F-4F kit that comes
with the wrong ones. Though the majority of users will incorporate these with
their Hasegawa builds, the truth is that they will fit just about any 1/48
Phantom kit I can think of. About the only area one will have to be careful is
when removing these from the resin sprue. One will have to take care not to
accidentally cut the little pin on the stabs where it fits into the fuselage. If
you do slip, using a section of paper clip will fix the goof.
As usual with Cutting Edge, the parts are superbly molded and
should remove easily from the resin pour stubs. The result will be something a
bit different from the norm.
Review set
where you can get yours direct.